Gear Diff Rebuild Kit - Mi5/evo,Mi6/evo SCHUMACHER

Hexagonal 3D TPU Bumper - FT8

IMPACT SERVO SAVER - MI5-MI7,FT,E4/5,ICON/2,A3

LIPO MOUNTING MOULDINGS SET - MI7,FT,MI8

Longitudinal Stiffening Post - FT8 SCHUMACHER

Vul hieronder de algemene informatie van het product in. Dit zijn de basisgegevens van een product. De productnaam is een verplicht veld omdat deze altijd getoond wordt.

M3 Black Alloy Washers 0.5mm (pk12) Item No. U4862 SCHUMACHER

M3 Black Alloy Washers 1.00mm (pk10)SCHUMACHER

M3 Black Alloy Washers 3.00mm (pk10)SCHUMACHER

M3 BRASS INSERTS - PK10

Nano Shock Set - Mi9 (pk4)

Light oil for bearings and transmissions etc. Easy to use pen type needle applicator.

Roll Bar Set - Mi8,FT8 (pk8)SCHUMACHER
Mi8 Anti roll bar set. 

Front and rear.

2x 1.1mm
2x 1.2mm
2x 1.3mm
2x 1.4mm

SCHUMACHER 108T x 3.0mm MBL Belt FT8

SCHUMACHER Alloy ARB Drop Link - Mi8,FT8,Mi9 (pr)

This differential/spool eccentric allows you to adjust the height of the diff/spool to a new 'High' position compared to the standard kit 'Low' position. 

The smart looking piece as normal is used to adjust the belt tension, as well as being able to fine tune the feeling of the car.

Normally a higher front spool smooths the steering response compared to the standard low kit setting.

A higher rear diff can give the car more drive out of the turns keeping it flatter.  A low standard position normally gives a little more side bite.

A worthwhile item to have available to tune your Mi7 to different track conditions. 

SCHUMACHER-Alloy-LiPo-Mount-pr-Mi7,FT,Mi8,FT8,Mi9

SCHUMACHER Alloy LiPo Swivel - Mi8,L1R,FT8,ST2,LD3,Mi9 (pr)
Bling up your car with this cool looking black alloy LiPo swivel.

Increased strength over kit item.

When combined with U8438 Alloy Lipo Mounts - LD2 (pr) we suggest using a plastic LiPo swivel or a plastic height adjustment washer when using these as an insulator from short circuit.

SCHUMACHER Alloy Shock Top Ball - Mi8,FT8,Mi9 (pr)
A slicker solution for mounting the shock tops to the shock tower.

Just 1 screw with a locating pip into the other holes in the tower.